Kb-electronics Multi Speed Board Manuel d'utilisateur télécharger pdf (Page 10)

B. Removing Terminal

Block TB1 from the

KBMG – Remove Terminal

Block TB1 from the KBMG

by rocking it back and forth

or using a flat blade screw-

driver to gently pry it off. The

removed terminal block will

not be used and may be dis-

carded. See Figure 9.

C. Modifying the KBMG

Finger-Safe Cover – Once

the KBMG finger-safe cover

is removed, it has to be mod-

ified to accommodate the

KBMG Multi-Speed Board.

Cut out the finger-safe cover

panel at seven (7) places as

shown in Figure 10, on page

9. Note: Some finger-safe covers may already have the cover removed.

D. Installing the KBMG Finger-Safe Cover – Once the KBMG finger-safe cover has

been modified, it can be installed onto the KBMG. Initially, use only the two (2) 5-40 X

1/4” socket head screws, using the supplied 3/32” hex key. Do not over tighten these

screws or damage may result to the KBMG finger-safe cover. See Figure 6 on page 6.

KBMG

Terminal Block

TB1

FIGURE 9 – REMOVING

TERMINAL BLOCK TB1 FROM THE KBMG

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Kb-electronics Multi Speed Board Manuel d'utilisateur Page 10